Inside the appliance
Door seal. In plain English.
Liebherr's troubleshooting tables call the door seal interchangeable, replaceable without special tools. A seal that has slipped out of its groove is listed as a cause of ice or condensation. If it is damaged, book a technician.

Where it fits.
Door seal in the appliance
Liebherr's tables place the seal in a groove on the door. They do not describe its position further.
The image shows a typical example of this part. It does not say which replacement fits your model.
What changes when the cooling system needs attention.
Door seal problems can show up as warmer shelves or an alarm that keeps returning. The part is tested before anyone decides it is the cause.

Liebherr freezer not cold enough
A Liebherr freezer that runs warm often has a simple cause that the user guide lists: a door left ajar, a blocked ventilation grille, a hot room, a heat source nearby, too much fresh food added without SuperFrost, or a setting that is too warm. Work through that list. If it stays warm, book a technician.

Liebherr freezer does not work or will not turn on
If a Liebherr freezer is dead, the user guide lists four things for the owner to rule out first: the freezer was never switched on, the plug is not seated in the wall socket, the fuse behind that socket is not good, or the IEC socket on the back is not plugged in properly. After those, book a technician. Keep the door shut meanwhile.
Owner care, within the model instructions.
Unplug the appliance before any check of your own. Watch for meltwater on the floor and for frost-covered shelves that can stick to skin. Never touch a wet plug, open a cover or go beyond what your model's owner manual allows.
- 1
Look at the groove
For ice or condensation inside, Liebherr's remedy is to check that the door seal sits well in its groove.
- 2
Look for damage
Check the seal all the way around for tears or a loose section. Liebherr calls a defective seal a reason to replace it.
- 3
Note the model
Read the model and serial number from the type plate before you call. A seal is matched to the unit.
Cleaning or replacement?
Leave internal testing to a technician.
The seal is torn, hardened or loose in more than one place.
Ice or condensation returns after you reseat the seal.
Arrange a diagnosticSources and model boundaries.
These documents support the Door seal guidance. Pick the manual that matches your model.
- User Guide
- User Guide
- User Guide
Keep the manual for your exact model handy. See how we research these pages.
Can a Liebherr door seal be replaced?
Liebherr's tables say it is interchangeable and needs no special tools. We confirm the seal for your model, then fit it on the visit.
Why is there ice or condensation inside?
Liebherr lists a seal that has slipped out of its groove as one cause. Reseating it is the first check.
Does the seal cause a message on the display?
The tables we read list no display message for the seal. A message and a seal problem are separate checks.
Is warm exterior wall a seal problem?
No. On the Liebherr tables a warm outer surface is normal: heat from the refrigerant circuit keeps condensation from forming.
Liebherr alarms, symptoms, cooling parts, repair visits
From the message to what to do next.
Liebherr refrigerator not cold enough
If a Liebherr refrigerator is not cold enough, the user guides list the same few causes: the door is not closed properly, the room is too warm, the door has been opened too often or too long, the temperature is set too warm, a heat source is close, or too much fresh food went in. Check those first. If it stays warm, book a technician.
Refrigerator repair
Book a diagnostic for your exact model, carried out beside the unit.
Find your metro
Office details, plus the access notes to pass on to us.

