Inside the appliance
IceMaker cleaning and TubeClean. In plain English.
Liebherr advises cleaning the IceMaker at first start-up, after more than 5 days idle with a water connection, and whenever it is due. TubeClean flushes the IceMaker water lines. If ice stays away after a water connection check, Liebherr says to clean the IceMaker.

Where it fits.
IceMaker cleaning and TubeClean in the appliance
At the IceMaker in the freezer section, with the drawer beneath it.
The image shows a typical example of this part. It does not say which replacement fits your model.
What changes when the cooling system needs attention.
IceMaker cleaning and TubeClean problems can show up as warmer shelves or an alarm that keeps returning. The part is tested before anyone decides it is the cause.
Owner care, within the model instructions.
Unplug the appliance before any check of your own. Watch for meltwater on the floor and for frost-covered shelves that can stick to skin. Never touch a wet plug, open a cover or go beyond what your model's owner manual allows.
- 1
Empty and seat the drawer
TubeClean needs an emptied, fully pushed-in IceMaker drawer and an activated IceMaker.
- 2
Start TubeClean
Set an empty 1.5 l (1.59 qt) container, no taller than 10 cm, under the IceMaker and activate TubeClean. The flush runs up to 60 minutes and stops itself.
- 3
Wash the drawer
Take out the drawer and container, wash the drawer in warm soapy water, then push it back. Ice making resumes by itself.
- 4
Discard the first cubes
Liebherr says to throw away cubes from the first 24 hours, or 48 hours with a water filter.
Cleaning or replacement?
Leave internal testing to a technician.
No ice comes after the water connection was checked and the IceMaker cleaned.
TubeClean will not finish, or the reminder returns at once.
Arrange a diagnosticSources and model boundaries.
These documents support the IceMaker cleaning and TubeClean guidance. Pick the manual that matches your model.
- User Guide, section 9.8.7 Cleaning the IceMaker (CBNsth 779i)
Keep the manual for your exact model handy. See how we research these pages.
When should the IceMaker be cleaned?
Liebherr recommends it at initial start-up, and after more than 5 days unused with a water connection.
What does TubeClean do?
Liebherr says it cleans the IceMaker lines, flushing the water pipes.
How long does the flush last?
Up to 60 minutes, Liebherr says, and the function switches itself off when done.
How do I clean it by hand?
Pull the drawer, wash it with soapy lukewarm water and slide it back in.
Liebherr alarms, symptoms, cooling parts, repair visits
From the message to what to do next.
Check water connection
Check water connection is a reminder on Liebherr Touch & Swipe models with a plumbed IceMaker. It means the IceMaker is active but is no longer being supplied with water. Check the connection, or deactivate the IceMaker; if the line is fine, clean the IceMaker.
Liebherr IceMaker not making ice cubes
For a Liebherr IceMaker that is not making ice cubes, the user guide lists three causes: the IceMaker is not switched on, its drawer is not closed properly, or the water connection is not open. Fix whichever applies. If the freezer also shows Check water connection, the guide adds a cleaning step. Otherwise, book a technician.
Ice maker repair
Book a diagnostic for your exact model, carried out beside the unit.
Find your metro
Office details, plus the access notes to pass on to us.

