Inside the appliance
Water filter. In plain English.
Liebherr says its water filter absorbs deposits and reduces chlorine taste. It recommends a replacement every 6 months, or sooner if the flow drops. A Replace water filter reminder appears on models that have one.

Where it fits.
Water filter in the appliance
Behind the lowest fridge drawer on the CBNsth 779i; behind the ventilation grille on the MF freezer columns.
The image shows a typical example of this part. It does not say which replacement fits your model.
What changes when the cooling system needs attention.
Water filter problems can show up as warmer shelves or an alarm that keeps returning. The part is tested before anyone decides it is the cause.

Liebherr freezer not cold enough
A Liebherr freezer that runs warm often has a simple cause that the user guide lists: a door left ajar, a blocked ventilation grille, a hot room, a heat source nearby, too much fresh food added without SuperFrost, or a setting that is too warm. Work through that list. If it stays warm, book a technician.

Liebherr freezer does not work or will not turn on
If a Liebherr freezer is dead, the user guide lists four things for the owner to rule out first: the freezer was never switched on, the plug is not seated in the wall socket, the fuse behind that socket is not good, or the IEC socket on the back is not plugged in properly. After those, book a technician. Keep the door shut meanwhile.
Owner care, within the model instructions.
Unplug the appliance before any check of your own. Watch for meltwater on the floor and for frost-covered shelves that can stick to skin. Never touch a wet plug, open a cover or go beyond what your model's owner manual allows.
- 1
Read the reminder
Touch the display for the reminder text. Liebherr says it appears again 6 months after the filter is replaced.
- 2
Check the flow
Liebherr says to replace the filter at least every 6 months or if the flow rate drops significantly.
- 3
Flush after fitting
Liebherr's note says new filters may contain suspended solids. After a change, draw and dispose of 3 l (3 qt) of water at the InfinitySpring.
Cleaning or replacement?
Leave internal testing to a technician.
Water keeps dripping near the filter after you have changed it.
The flow stays weak with a new filter.
Arrange a diagnosticSources and model boundaries.
These documents support the Water filter guidance. Pick the manual that matches your model.
- User Guide
- User Guide
- Use and Care Manual Freezer
Keep the manual for your exact model handy. See how we research these pages.
How often does a Liebherr water filter change?
Liebherr recommends every 6 months under its usage conditions, or sooner if the flow rate drops.
Where is it?
On the CBNsth 779i it sits behind the lowest drawer in the fridge section. On the MF freezer columns it is behind the ventilation grille.
Can the old filter go in the trash?
Liebherr says the filter contains carbon and can go with regular household waste.
Do I shut off the water to change it?
The Monolith freezer guide says it is not required to turn off the supply when removing or inserting the filter.
Liebherr alarms, symptoms, cooling parts, repair visits
From the message to what to do next.
Replace water filter
Replace water filter is a reminder on Liebherr refrigerators with a water filter. Liebherr recommends replacing the water filter every 6 months; the reminder then returns after 6 months. It is routine upkeep, not a problem.
Liebherr refrigerator not cold enough
If a Liebherr refrigerator is not cold enough, the user guides list the same few causes: the door is not closed properly, the room is too warm, the door has been opened too often or too long, the temperature is set too warm, a heat source is close, or too much fresh food went in. Check those first. If it stays warm, book a technician.
Refrigerator repair
Book a diagnostic for your exact model, carried out beside the unit.
Find your metro
Office details, plus the access notes to pass on to us.

