Inside the appliance
InfinitySpring water dispenser. In plain English.
InfinitySpring is the built-in water dispenser in some Liebherr refrigerators, such as the CBNsth 779i. It serves drinking water at about the fridge temperature, through a water tank behind the lowest drawer. Push a glass against the dispenser button, and clean the outlet and draw 2 l before first use.

Where it fits.
InfinitySpring water dispenser in the appliance
Behind the lowest drawer in the fridge section on the CBNsth 779i, per the guide.
The image shows a typical example of this part. It does not say which replacement fits your model.
What changes when the cooling system needs attention.
InfinitySpring water dispenser problems can show up as warmer shelves or an alarm that keeps returning. The part is tested before anyone decides it is the cause.

Liebherr refrigerator not cold enough
If a Liebherr refrigerator is not cold enough, the user guides list the same few causes: the door is not closed properly, the room is too warm, the door has been opened too often or too long, the temperature is set too warm, a heat source is close, or too much fresh food went in. Check those first. If it stays warm, book a technician.

Liebherr refrigerator does not work, display is off
When a Liebherr refrigerator does not work or its display is off, the guides list a short set of checks: whether the appliance is turned on, whether the power cord is properly inserted, whether the circuit breaker or fuse is in order, and on Touch & Swipe models whether the IEC socket is plugged in. If those pass, book a technician.
Owner care, within the model instructions.
Unplug the appliance before any check of your own. Watch for meltwater on the floor and for frost-covered shelves that can stick to skin. Never touch a wet plug, open a cover or go beyond what your model's owner manual allows.
- 1
Push the glass against the button
Press your glass against the dispenser pushbutton. The outlet unit moves out and water pours into the glass. Remove the glass slowly to avoid splashes.
- 2
Refill flow for large amounts
If dispensing larger quantities and the flow stops, remove the water tank and push your container against the button again.
- 3
Bleed and clean before first use
Before first use the guide says to bleed the water system and clean the InfinitySpring, with the water supply connected and the tank fitted.
- 4
Clean the outlet
Hold the bottom pushbutton, wipe the water outlet with a soft damp cloth, lukewarm water and a little washing-up liquid, release, then draw and dispose of 2 l.
- 5
Expect it to pause in some modes
SabbathMode and CleaningMode list the InfinitySpring as out of order while they are active.
Cleaning or replacement?
Leave internal testing to a technician.
Book a visit when no water comes with the supply open, the tank fitted and the display showing no special mode.
Book a visit when water leaks from the outlet or the tank area.
Arrange a diagnosticSources and model boundaries.
These documents support the InfinitySpring water dispenser guidance. Pick the manual that matches your model.
- User Guide
Keep the manual for your exact model handy. See how we research these pages.
What is InfinitySpring on a Liebherr refrigerator?
It is the built-in water dispenser on some models. The guide says the water temperature depends on the temperature in the fridge.
How do I dispense water?
Push a glass against the dispenser pushbutton. The outlet unit moves out and water pours. Remove the glass slowly to avoid splashes.
Where is the InfinitySpring water tank?
The CBNsth 779i guide says the InfinitySpring is located behind the lowest drawer in the fridge section.
Why does the water dispenser not work in Sabbath mode?
The guide lists the InfinitySpring as out of order while SabbathMode or CleaningMode is active. Switch the mode off to use it again.
Liebherr alarms, symptoms, cooling parts, repair visits
From the message to what to do next.
Liebherr refrigerator not cold enough
If a Liebherr refrigerator is not cold enough, the user guides list the same few causes: the door is not closed properly, the room is too warm, the door has been opened too often or too long, the temperature is set too warm, a heat source is close, or too much fresh food went in. Check those first. If it stays warm, book a technician.
Refrigerator repair
Book a diagnostic for your exact model, carried out beside the unit.
Find your metro
Office details, plus the access notes to pass on to us.

