Start from the symptom
Liebherr refrigerator does not work, display is off.
When a Liebherr refrigerator does not work or its display is off, the guides list a short set of checks: whether the appliance is turned on, whether the power cord is properly inserted, whether the circuit breaker or fuse is in order, and on Touch & Swipe models whether the IEC socket is plugged in. If those pass, book a technician.

Start with safe observations.
Unplug the appliance before any check of your own. Watch for meltwater on the floor and for frost-covered shelves that can stick to skin. Never touch a wet plug, open a cover or go beyond what your model's owner manual allows.
- 1
Confirm it is switched on
Both guides begin with whether the appliance is turned on. On a Touch & Swipe model, that includes the power setting in the display menu.
- 2
Seat the power cord
Check that the cord is properly inserted in the outlet. The Touch & Swipe guide also lists the IEC socket on the appliance.
- 3
Test the circuit
The Use and Care Manual asks whether the circuit breaker or fuse is in operating condition. Reset the breaker, or test the socket with a lamp.
- 4
Keep the door shut in an outage
For a power failure, the Touch & Swipe guide says to keep the appliance closed.
Systems a technician may investigate.
We test the refrigerator in place before we name any part. You approve the quote first, then the work starts.

Door seal
Liebherr's troubleshooting tables call the door seal interchangeable, replaceable without special tools. A seal that has slipped out of its groove is listed as a cause of ice or condensation. If it is damaged, book a technician.

Fan and air vents
Liebherr's manuals tell owners to keep the air vents on the fan free and never block its air slits. A whirring or murmuring sound is listed as normal operation. A wine cooler fan may also run while its compressor is idle.

Ventilation grille
Liebherr's wine cabinet guide lists insufficient ventilation as a cause of poor cooling, and the remedy is to clear and clean the ventilation grille. On other models the grille covers a dust filter or a water filter.

Air filter in the toe kick
On a Liebherr HCB 2092G or CBS 2092G, the Air Filter LED lights when the filter in the toe kick area needs cleaning. After cleaning you reset the LED in setup mode. A wine cooler guide has the same dust filter behind its grille.

Water filter
Liebherr says its water filter absorbs deposits and reduces chlorine taste. It recommends a replacement every 6 months, or sooner if the flow drops. A Replace water filter reminder appears on models that have one.

FreshAir filter
Liebherr's guides tell owners to change the FreshAir activated charcoal filter every 6 months, and the display shows a reminder. A fridge and a wine cabinet each have one. The filter is a household-waste item.

BioFresh drawers
BioFresh is Liebherr's drawer zone just above freezing, 0 to 3 °C (32 to 37 °F) on the CBNsth 779i. You adjust it with the BioFresh B-Value, B5 on delivery. B1 to B4 can bring the zone to 0 °C, where food could freeze.

Interior LED light
Liebherr's tables say the interior light stays off if the unit is off or the door has been open over 15 minutes, when it switches off by itself. A damaged LED or cover is a case for a technician.

NoFrost defrosting
Liebherr's NoFrost freezers defrost automatically: moisture collects on the evaporator, then is periodically defrosted and evaporated. The SF 5291 guide says the unit never needs manual defrosting, though water droplets may collect on its floor.
Read the related care guide.

Liebherr door alarm: set the delay that suits you.
A Liebherr door alarm sounds when the door stays open too long. On the SF 5291 freezer and the W5250 and UW 3710 wine cabinets you pick 1, 2 or 3 minutes, or off, and the alarm is on at delivery. The HW wine coolers sound after 180 seconds. [1][3][4][6]

Find the service number on your Liebherr.
Open the appliance information screen on a Touch model, or look for the plate inside the appliance: behind the drawers on the SF 5291, bottom of the interior on the URh 375i and UW 3710, bottom left on the W5250. It lists the name, the service number and the serial number. [1][2][3][4]
When observation becomes a service request.
Leave internal testing to a technician.
Cord, outlet and fuse are good and the display is still off.
The refrigerator starts and then shows an Error message.
It loses power on its own and the outlet is confirmed live.
Arrange a diagnosticSources and model boundaries.
These documents support the Liebherr refrigerator does not work, display is off guidance. Pick the manual that matches your model.
- User Guide
- Use and Care Manual For Refrigerators
Keep the manual for your exact model handy. See how we research these pages.
The refrigerator display is off. Is it broken?
Not yet. Liebherr's guides first ask whether the appliance is turned on, the cord is inserted and the breaker or fuse works. A dead outlet looks the same as a dead appliance.
What should I do during a power cut?
The Touch & Swipe guide says to keep the appliance closed. Once the power returns, check the display for a Power failure alarm and confirm it.
Is the interior light off too?
The Use and Care Manual lists an interior light that does not come on as a separate item and asks if the appliance is turned on. A light and a display that are both off suggest power.
Can I just replace the fuse myself?
Checking the fuse or breaker is an owner step in the guides. Anything beyond the outlet, or a repeated trip, is for a technician.
Liebherr alarms, symptoms, cooling parts, repair visits
From the message to what to do next.
Power failure alarm
Power failure alarm on a Liebherr Touch & Swipe refrigerator-freezer appears when the freezing temperature rose because of a power outage. The appliance cools back on its own, but you confirm the message to clear it. Check the food; a repeat with steady power needs a technician.
Liebherr refrigerator not cold enough
If a Liebherr refrigerator is not cold enough, the user guides list the same few causes: the door is not closed properly, the room is too warm, the door has been opened too often or too long, the temperature is set too warm, a heat source is close, or too much fresh food went in. Check those first. If it stays warm, book a technician.
Refrigerator repair
Book a diagnostic for your exact model, carried out beside the unit.
Find your metro
Office details, plus the access notes to pass on to us.