What it means
The Air filter LED on a Liebherr HCB 2092G or CBS 2092G lights when the air filter in the toe kick area needs cleaning. It is routine upkeep, not a problem. Clean the filter and the light should go out.
Liebherr refrigerator Air filter LED / Filters and reminders
The Air filter LED on a Liebherr HCB 2092G or CBS 2092G lights when the air filter in the toe kick area needs cleaning. It is routine upkeep, not a problem. Clean the filter and the light should go out.
Also shown as Air filter LED
The Air filter LED on a Liebherr HCB 2092G or CBS 2092G lights when the air filter in the toe kick area needs cleaning. It is routine upkeep, not a problem. Clean the filter and the light should go out.
Keep fingers clear of any moving parts while you reach in at floor level.
The LED stays lit after you clean the filter.
Your Liebherr steps, stored on this device alone

The air filter sits in the toe kick area at the bottom front of the appliance.

The guide says the filter has to be cleaned when the LED lights.

A light that stays on after cleaning needs a technician.
Give us the model number and what you have already tried, then start your request below.
Book a visit


A simplified drawing of a cooling unit; the inside differs between built-in, freestanding and column models. Tap any outlined part to open its photo and the check that belongs to it.

Component reference
On a Liebherr HCB 2092G or CBS 2092G, the Air Filter LED lights when the filter in the toe kick area needs cleaning.
Read the definitionWhen this LED lights up, the air filter in the toe kick area has to be cleaned.
Read the supporting manualBegin with the first check: the air filter sits in the toe kick area at the bottom front of the appliance.
Read the supporting manualKeep fingers clear of any moving parts while you reach in at floor level.
Read the supporting manualThe Air filter LED is a cleaning prompt. It is not an alarm, and it is separate from the Power failure LED and the Temperature alarm on the same panel.
Read the supporting manualManufacturer document
Liebherr-Hausgeräte (US market edition; linked from https://www.liebherr.com/en-us/p/ecbn-8872-3033405)
Models: HCB 2092G, CBS 2092G
PDF creation date Fri Jan 10 14:22:16 2025 EET; file tag ECBN8872_337; cover: HCB 2092G / CBS 2092G NoFrost combined refrigerator-freezers with IceMaker, 7083 476-00; V: 01_2025 / PDF p. 9
Applies to the Liebherr HCB 2092G / CBS 2092G NoFrost combined refrigerator-freezers with IceMaker. Source: Use and Care Manual (V: 01_2025), checked November 2026.
When this LED lights up, the air filter in the toe kick area has to be cleaned.
The air filter sits in the toe kick area at the bottom front of the appliance.
Any of these: The LED stays lit after you clean the filter.
Applies to the Liebherr HCB 2092G / CBS 2092G NoFrost combined refrigerator-freezers with IceMaker.
The guide ties it to the filter needing cleaning, not to a fixed schedule.
No. It is routine upkeep.
Liebherr alarms, symptoms, cooling parts, repair visits
The Power failure LED on a Liebherr HCB 2092G or CBS 2092G means the freezer temperature rose too high in the last hours or days because of a power failure. The freezer display flashes too. Touch the alarm icon to read the highest temperature, and check the food.
If a Liebherr refrigerator is not cold enough, the user guides list the same few causes: the door is not closed properly, the room is too warm, the door has been opened too often or too long, the temperature is set too warm, a heat source is close, or too much fresh food went in. Check those first. If it stays warm, book a technician.
On a Liebherr HCB 2092G or CBS 2092G, the Air Filter LED lights when the filter in the toe kick area needs cleaning. After cleaning you reset the LED in setup mode. A wine cooler guide has the same dust filter behind its grille.
Book a diagnostic for your exact model, carried out beside the unit.
Office details, plus the access notes to pass on to us.