On this page
- CleaningMode turns the fridge section off, keeps the light on and ends by itself after 60 minutes. 1
- No steel wool, scouring pads, caustic or acid cleaners, concentrated cleaners, solvents or steam cleaners. 12
- Door racks and the holder for the split shelf may go in the dishwasher up to 60 °C (140 °F). 1
- Water droplets or a thin layer of frost on the back wall are normal; clean the drain hole regularly. 1
How do I prepare the refrigerator for cleaning?#
Empty it, then either pull the power plug or switch on CleaningMode. The URh 375i manual gives both options as the preparation for cleaning. Disconnecting is the older way; CleaningMode is built into the Touch & Swipe display. 1
The warning that goes with it is brief: there is a danger of electric shock, so unplug the refrigerator or disconnect the power, and do not damage the refrigerant circuit, which is a risk of fire. 1 The Monolith MRB manual adds that the power cord should be disconnected or the circuit breaker turned off. 2
What exactly does CleaningMode do?#
CleaningMode switches the fridge section off, turns the interior lighting on, and silences reminders, warnings and signal tones. The status display shows CleaningMode all the time, and the mode ends by itself after 60 minutes. 1
It exists so you can work comfortably: the light is on, the cooling is off, nothing beeps. Because it relates to the fridge compartment only, a freezer next to it is not affected. 1
- 1
- 2
- 3
- 4
Reminders and warnings are not shown while the mode runs. 1 So if a door alarm would normally sound, it will not. Close the door behind you when you leave the kitchen.
What may I clean it with?#
Soft cloths and a pH-neutral all-purpose cleaner or lukewarm water with a little detergent. Liebherr rules out steel wool, scouring sponges, caustic or abrasive products, and cleaners containing sand, chloride or acids. Steam cleaners are not allowed. 12
The Monolith manual lists the same bans in other words: no abrasive or scouring pads, no concentrated cleaning agents, no abrasive or acid-based cleaners or chemical solvents. 2 It also warns against an overly wet sponge or cloth, so that cleaning water does not penetrate the electrical components. 2
| Part | How Liebherr says to clean it |
|---|---|
| Housing | Soft clean cloth; lukewarm water with neutral cleaner if very dirty; glass cleaner on glass |
| Interior plastic and metal | Soft cloth, lukewarm water and a little detergent |
| Shelves, split shelves, drawers | Soft cloth, lukewarm water and a little dish soap |
| Pull-out rails | Slightly dampened cloth only; no water in the rail guides |
| Door racks, split-shelf holder | Dishwasher up to 60 °C (140 °F) |
| Drain hole | Remove deposits with a thin item such as a cotton bud |
Where is the drain hole and why does it matter?#
On the URh 375i, defrosting is automatic: the water from the thawing process runs out through a drain opening and evaporates. Clean the drain hole regularly with a cotton bud or a similar thin item so deposits do not block it. 1
Droplets of water or a thin layer of frost or ice on the rear wall are described as a completely normal part of the appliance's function, and you do not have to remove them. 1
Never fight the frost. Do not use mechanical devices, electrical heating, steam cleaning equipment, naked flames or defrosting sprays to speed up defrosting, and do not remove ice with sharp objects. 1 Our refrigerator noises page and the door seal entry are the next stops if the fridge also sounds odd or the seal looks loose.
How do I take shelves, drawers and racks out?#
Follow the pictures for your model, and empty the shelf first. A single-piece shelf lifts at the front and slides out; a split shelf slides together or apart in two parts; door racks lift up and come off to the front; drawers pull out to the stop and then come off. 1
Some details are worth remembering. Liebherr recommends using the door racks in the position they have from delivery. 1 Keep the fan air slots on the rear wall clear, because insufficient ventilation increases energy consumption and reduces cooling performance. 1 And leave the model plate alone: on the MRB it is behind the left drawer, and on the URh 375i it sits on the bottom inside. 12
The FreshAir carbon filter sits in a compartment above the fan. The manual says to change it every 6 months and that it can go out with household waste; our FreshAir filter guide has the details. 1
Is cleaning a wine cabinet any different?#
The rules are the same, with a few extras. The W5250 manual starts with the power plug: empty the cabinet, pull out the plug, and clean the housing, interior and equipment with soft cloths and lukewarm water, never steam. The bottle shelf gets a damp, lint-free cloth. 3
A wine cabinet also has a yearly job that a refrigerator does not: dust deposits increase energy consumption, so the dust should be removed once a year from the refrigerating machine and the heat exchanger metal grid at the back. 3 And the FreshAir activated charcoal filter in a wine cabinet is changed every 6 months. Wine develops constantly according to its ambient conditions, so air quality is essential. 3
After cleaning, wipe the cabinet and its equipment dry, connect and switch on, and repeat the cleaning regularly. 3 Our FreshAir guide covers the filter reminder, and the energy saving guide explains why the dust matters.
What do I do when I am done?#
Wipe the appliance and the parts dry, put the parts back, reconnect and switch on, and restock only when the fridge is cold enough. Repeat the cleaning regularly. 12
On a Monolith with BioFresh drawers, the order is: place the drawer on the rails, make sure the rails are fully extended and aligned with the front of the drawer, slide it in, replace the other parts and the food, and turn the appliance on. 2 Our BioFresh guide explains the lid and B-Value.
What should I check while everything is empty?#
Check three things: the door seal, the ventilation grille and the interior light. All three are named in the URh 375i troubleshooting tables. 1
A seal that has slipped out of its groove is a listed cause of frost and condensation, so press it back into place. Insufficient ventilation is a listed cause of a fridge that is not cold enough, and the remedy is to clear and clean the ventilation grille. 1 Then look at the light.
If the light stays dark with the door open, remember that the interior lighting switches off by itself after about 15 minutes with the door open. A LED that stays dark otherwise, or a damaged cover, is a service matter. 1 See the interior light entry and the ventilation grille entry.
Which of these problems need a visit?#
If the fridge does not cool again after cleaning, if water collects even though the drain hole is clear, or if a seal or rail is damaged, book a visit. Door seals are interchangeable and can be replaced without special tools, but that is a service job. 1
Our independent repair company is separate from Liebherr, and a unit within Liebherr's own warranty is repaired through Liebherr. For other units, book a visit through the refrigerator repair page. The technician agrees the price with you before any work starts. The exact cost is confirmed after the on-site diagnostic.
Sources#
- User GuideLiebherr-Hausgeräte (US market edition; linked from https://www.liebherr.com/en-us/p/urh-375i-3033413) · PDF created 07.09.2026; file tag URh375i_137; US product pages URh 365i, URh 375i · PDF pages 15, 20, 22, 23, 24, 25, 27
- Use and Care Manual For RefrigeratorsLiebherr-Hausgeräte (US market edition; linked from https://www.liebherr.com/en-us/p/erbhi-9670-3033413) · PDF created 13.10.2023; file tag ERBhi9970_137; cover: MRB 2400 / MRB 2410 / MRB 3000 / MRB 3010 / MRB 3600 / MRB 3610, 7085 975-01 · PDF pages 19, 20
- User GuideLiebherr-Hausgeräte (US market edition; linked from https://www.liebherr.com/en-us/p/wpsd-5252-3033484) · PDF created 07.07.2025; file tag WPsd5252_137; cover: W5250 (freestanding wine cabinet); US product page WPsd 5252 · PDF pages 9, 22, 23




